Six numbers that determine whether your PE water supply pipe will last long-term or fail in short term
When we talk about black masterbatch for potable water pipes, we’re not talking about color. We’re talking about UV protection, mechanical integrity, and decades of service life. Here are the six mandatory physicochemical indicators every batch must...
Carbon Black Dispersion: Check the Concentration Before You Check the Slide
Where the black field comes from Every few months someone presses a handful of pellets into a plaque, looks at it under the microscope, and tells us the dispersion is poor. The field comes out black. It would. The masterbatch is 40% carbon black. At ...
Glass-Filled Nylon: 0.1% Moisture Comes Before Melt Temperature
Silver streaks show up on a glass-filled nylon part, and the first move on the floor is always the same: raise the temperature. 270 to 300. It only gets worse. Two numbers sit at the top of the process sheet, and their order matters — drying decides ...
MFI Testing for Masterbatch: How It's Measured and Why It Predicts Dispersion
(一) How it's measured MFI — melt mass-flow rate (MFR), expressed in g/10 min — answers one question: how many grams of melt pass through a standard die (Ø2.095 mm × 8 mm) in ten minutes at a fixed temperature and load. We follow ISO 1133-1 / ASTM D12...
How is the black masterbatch acting in water supply pipe
Jolink Masterbatch strictly adheres to both QB/T 4132-2010 and GB/T 13663 standards, meeting stringent requirements for water supply grades in everything from carbon black selection to additive systems. Using virgin tank/furnace process carbon black...
Why is the particle size of our black masterbatch so uniform?
Pick up a handful of our black masterbatch and spread it out. The pellets come out the same length and the same thickness, as if they had all been cut from one die. That look is not luck. It comes from holding every stage of the line to one standard,...
Search
Category
Recent Posts